Fanuc Series 15i/150i-MA (Programming) Operators Manual

13.FUNCTIONS TO SIMPLIFY PROGRAMMING PROGRAMMING B-63324EN/03
- 330 -
- Retraction feedrate
To the feedrate used for each retraction operation, an override value
from 1% to 200% can be applied by using parameter No. 5883.
During rigid tapping, the retraction feedrate override function is
enabled even in retraction from point Z to point R.
Limitation
The limitations set for the rigid tapping cycle and reverse rigid tapping
cycle apply.
Example
Feedrate along the Z-axis: 1000 mm/min
Spindle speed: 1000 min
-1
Thread lead: 1.0 mm
G94 ; Feed per minute command
G00 X120.0 Y100.0 ; Positioning
G84.2 Z-100.0 R-20.0 F1000 S1000 Q10.0 ; Rigid tapping
CAUTION
The peck rigid tapping cycle command for rigid
tapping is enabled by the Q command in the rigid
tapping cycle or reverse rigid tapping cycle mode or in
a block specifying G84.2 (G84.3).

Leave a Reply

Your email address will not be published. Required fields are marked *