Fanuc Series 15i/150i-MA (Programming) Operators Manual

1.GENERAL PROGRAMMING B-63324EN/03
- 14 -
1.2 FEED-FEED FUNCTION
Movement of the tool at a specified speed for cutting a workpiece is
called the feed.
Fig.1.2 (a) Feed function
Feedrates can be specified by using actual numerics.
For example, to feed the tool at a rate of 150 mm/min, specify the
following in the program:
F150.0
The function of deciding the feed rate is called the feed function (See
II-5).
Tool
Workpiece
Table
F
mm/min

Leave a Reply

Your email address will not be published. Required fields are marked *