Fanuc Series 15i/150i-MA (Programming) Operators Manual

13.FUNCTIONS TO SIMPLIFY PROGRAMMING PROGRAMMING B-63324EN/03
- 366 -
Example
N1 G90 X0 Y0 Z0 ; (1)
N2 G68 X10. Y0 Z0 I0 J1 K0 R30. ; (2)
N3 G68 X0 Y-10. Z0 I0 J0 K1 R-90. ; (3)
N4 G90 X0 Y0 Z0 ; (4)
N5 X10. Y10. Z0 ; (5)
(1) Carries out positioning to zero point H.
(2) Forms new coordinate system X’Y’Z’.
(3) Forms other coordinate system X’Y’Z’. The origin agrees with (0,
-10, 0) in coordinate system X’Y’Z.
(4) Carries out positioning to zero point H on coordinate system
X ’’Y’’Z ’’.
(5) Carries out positioning to (10, 10, 0) on coordinate system
X ’’Y’’Z ’’.
H
Z
YY
N4
30°
Z’
Z’’
X’’
H’ X
X’
H’’
N5
30°
Y’’
Fig.13.9 (d) Example of three-dimensional conversion

Leave a Reply

Your email address will not be published. Required fields are marked *