Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 368 -
14 COMPENSATION FUNCTION
General
This chapter describes the following compensation functions:
14.1 TOOL LENGTH OFFSET (G43,G44,G49)
14.2 TOOL OFFSET (G45 TO G48)
14.3 OVERVIEW OF CUTTER COMPENSATION C (G40 - G42)
14.4 DETAILS OF CUTTER COMPENSATION C
14.5 THREE-DIMENSIONAL TOOL COMPENSATION
(G40,G41)
14.6 TOOL COMPENSATION VALUES
14.7 NUMBER OF TOOL COMPENSATION SETTINGS
14.8 CHANGING THE TOOL COMPENSATION AMOUNT
14.9 SCALING (G50,51)
14.10 COORDINATE SYSTEM ROTATION (G68,G69)
14.11 TOOL OFFSETS BASED ON TOOL UNMBERS
14.12 TOOL AXIS DIRECTION TOOL LENGTH
COMPENSATION
14.13 ROTARY TABLE DYNAMIC FIXTURE OFFSET
14.14 THREE-DIMENSIONAL CUTTER COMPENSATION
14.15 DESIGNATION DIRECTION TOOL LENGTH
COMPENSATION
14.16 TOOL CENTER POINT CONTROL
14.17 CONTROL POINT COMPENSATION OF TOOL LENGTH
COMPENSATION ALONG TOOL AXIS
14.18 GRINDING WHEEL WEAR COMPENSATION
14.19 CUTTER COMPENSATION FOR ROTARY TABLE

Leave a Reply

Your email address will not be published. Required fields are marked *