Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 369 -
14.1 TOOL LENGTH OFFSET (G43,G44,G49)
This function can be used by setting the difference between the tool
length assumed during programming and the actual tool length of the
tool used into the offset memory. It is possible to compensate the
difference without changing the program.
Specify the direction of offset with G43 or G44. Select a tool length
offset value from the offset memory by entering the corresponding
address and number (H code).
Fig. 14.1 Tool length offset
Specify this distance as
the value of tool length
offset.
Tool assumed during
programming
Actual tool

Leave a Reply

Your email address will not be published. Required fields are marked *