Fanuc Series 15i/150i-MA (Programming) Operators Manual

1.GENERAL PROGRAMMING B-63324EN/03
- 18 -
2 Mounting a workpiece directly against the jig
3 Mounting a workpiece on a pallet, then mounting the workpiece
and pallet on the jig
Jig
Program zero point
Meet the tool center to the reference position.
And set the coordinate system specified by CNC at this position.
(Jig shall be mounted on the predetermined point from the reference
position.)
Workpiece
Jig
Pallet
(Jig and coordinate system shall be specified by the same as 2).

Leave a Reply

Your email address will not be published. Required fields are marked *