Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 385 -
14.4 DETAILS OF CUTTER COMPENSATION C
This section provides a detailed explanation of the movement of the
tool for cutter compensation C outlined in Section 14.6.
This section consists of the following subsections:
14.4.1 General
14.4.2 Tool Movement in Start-up
14.4.3 Tool Movement in the Offset Mode
14.4.4 Tool Movement in Offset Mode Cancel
14.4.5 Overcutting by Cutter Compensation
14.4.6 Interference Check
14.4.7 Cutter compensation by input from MDI
14.4.8 Vector Holding(G38)
14.4.9 Corner Circular Interpolation(G39)

Leave a Reply

Your email address will not be published. Required fields are marked *