Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 389 -
- SS represents a point where single block operation is performed
twice.
- SSS represents a point where single block operation is performed
three times.
- L means that the tool moves linearly.
- C means that the tool moves circularly.
- r represents a cutter compensation value.
- Intersection is the intersection of the programmed paths of two
blocks shifted by r.
- represents the center of the tool.

Leave a Reply

Your email address will not be published. Required fields are marked *