Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 410 -
- Command canceling the offset vector temporarily
During offset mode, if G92 (absolute zero point programming) is
commanded, the offset vector is temporarily cancelled and thereafter
offset mode is automatically restored.
In this case, without movement of offset cancel, the tool moves directly
from the intersecting point to the commanded point where offset vector
is canceled.
Also when restored to offset mode, the tool moves directly to the
intersecting point.
Before executing G28 (reference position return), G29 (return from
reference position), G30 (second, third, or fourth reference position
return), G30.1 (floating reference position return), or G53 (machine
coordinate system selection), cancel offset mode by issuing G40. If
any of these commands is issued in offset mode, the offset vector will
disappear temporarily.
S
Tool center path
Programmed path
L
L
L
L
S
S
N5
N6
N7
N8
G92 block
(G41)
N5 G91 G01 X300.0 Y700.0 ;
N6 X-300.0 Y600.0 ;
N7 G92 X100.0 Y200.0 ;
N8 G90 G01 X400.0 Y800.0 ;

Leave a Reply

Your email address will not be published. Required fields are marked *