Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 459 -
Explanation
- Increment system and valid range of tool offset values
The increment system and valid range of tool offset values depend on
the following parameters:
Parameter OFA(No.6002#0)
Parameter OFC(No.6002#1)
Parameter OFD(No.6004#0)
Parameter OFE(No.6007#0)
Table 14.6 (b) Unit and valid setting range of the tool offset value (metric input)
OFEOFDOFC OFA Unit Geometry offset
value
Wear offset value
0 0 0 1 0.01 mm ±9999.99 mm ±9999.99 mm
0 0 0 0 0.001 mm ±9999.999 mm ±9999.999 mm
0 0 1 0 0.0001 mm ±9999.9999 mm ±9999.9999 mm
0 1 0 0 0.00001 mm ±9999.99999 mm ±9999.99999 mm
1 0 0 0 0.000001 mm ±999.999999 mm ±999.999999 mm
Table 14.6 (c) Unit and valid setting range of the tool offset value (inch input)
OFE OFD OFC OFA Unit Geometry offset
value
Wear offset value
0 0 0 1 0.001 inch ±999.999 inch ±999.999 inch
0 0 0 0 0.0001 inch ±999.9999 inch ±999.9999 inch
0 0 1 0 0.00001 inch ±999.99999 inch ±999.99999 inch
0 1 0 0 0.000001 inch ±999.999999 inch ±999.999999 inch
1 0 0 0 0.0000001 inch ±99.9999999 inch ±99.9999999 inch

Leave a Reply

Your email address will not be published. Required fields are marked *