Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 460 -
14.6.1 Tool Compensation Memory A
The memory for geometric compensation and that for wear
compensation are not separated in tool compensation memory A.
Therefore, the sum of the geometric compensation amount and wear
compensation amount is set in the memory.
In addition, the memory for cutter compensation (for D code) and that
for tool length compensation (for H code) are not separated.
Example
Offset No. Compensation amount(geometric + wear ) D code/H
code
common
001 10.1 For D code
002 20.2 For D code
003 100.1 For H code
14.6.2 Tool Compensation Memory B
The memory for geometric compensation and that for wear
compensation are separated in tool compensation memory B. The
geometric compensation amount and wear compensation amount can
thus be set separately.
However, the memory for cutter compensation (for D code) and that for
tool length compensation (for H code) are not separated.
Example
Offset No. Compensation
amount(geometric +
wear)
For wear compensation D code/H
code
common
001 10.0 0.1 For D code
002 20.0 0.2 For D code
003 100.0 0.1 For H code
14.6.3 Tool Compensation Memory C
The memory for geometric compensation and that for wear
compensation are separated in the tool compensation memory C. The
geometric compensation amount and wear compensation amount can
thus be set separately.
In addition, separate memories are provided for cutter compensation
(for D code) and for tool length compensation (for H code).
Example
For D code For H codeOffset No.
For geometric
compensation
For wear
compensation
For geometric
compensation
For wear
compenation
001 10.0 0.1 100.0 0.1
002 20.0 0.2 200.0 0.2

Leave a Reply

Your email address will not be published. Required fields are marked *