Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 475 -
14.11 TOOL OFFSETS BASED ON TOOL NUMBERS
Cutter compensation data, tool length compensation data, and the tool
pot number can be set for a specific tool number (T code). Up to 300
sets of data can be set. If a certain tool number is specified, the pot
number corresponding to that tool number is output as a T code to the
PMC. If cutter compensation or tool length compensation is specified,
compensation is performed using the cutter compensation or tool
length compensation data set for the tool number.

Leave a Reply

Your email address will not be published. Required fields are marked *