Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 476 -
14.11.1 Tool Data Registration, Modification, and Deletion
Explanation
- Setting tool data
After all the registered tool data has been deleted, programmed tool
data can be registered.
- Adding or modifying tool data
The tool data programmed for a group can be added to or modified. If a
previously registered tool number is specified, the tool data for that tool
number is updated to specified data.
- Deleting tool data
Registered tool data can be deleted. If an attempt is made to delete the
tool data for the currently selected tool, a PS0425 alarm is issued. Any
attempt to delete tool data by specifying a tool number and pot number
fails if no tool matches the two numbers.
Format
Registration involving tool data deletion
Format Meaning of command
G10L70;
T-P-K-R-;
T-P-K-R-;
:
T-P-K-R-;
G11;
M02(M30);
10L70 : Starts the deletion of registered tool data and the
registration of new tool data.
T- : Tool number(0 to 99999999)
P- : Pot number(0 to 9999)
K- : Tool length offset(Note)
R- : Cutter compensation value(Note)
G11 : Ends the registration of setting data.
Adding and modifying tool data
Format Meaning of command
G10L71;
T-P-K-R-;
T-P-K-R-;
:
T-P-K-R-;
G11;
M02(M30);
10L7
1 : Starts the addition to or modification of registered
tool data.
T- : Tool number(0 to 99999999)
P- : Pot number(0 to 9999)
K- : Tool length offset(Note)
R- : Cutter compensation value(Note)
G11 : Ends the addition to or modification of setting data.
CAUTION
The unit of data and valid data range of tool length
offsets and cutter compensation values depend on
the settings of bit 0 (OFA) of parameter No. 6002, bit
1 (OFC) of parameter No. 6002, bit 0 (OFD) of
parameter No. 6004, and bit 0 (OFE) of parameter
No. 6007.

Leave a Reply

Your email address will not be published. Required fields are marked *