Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 480 -
Example
- Tool change method A
- Tool change methods B and C
- Tool change method D
Example:
N01 T10 ; : The tool pot number corresponding to T10 is output as a code signal.
N02 M06 T11 ; : The cutter compensation value and tool length compensation value
corresponding to T10 become valid. The T11 tool is returned to the
magazine.
The tool number specified in a block where M06 is specified specifies the number of the tool to
be returned to the magazine. Accordingly, the compensation values corresponding to the tool
number (T11) specified in the block where M06 is specified do not become valid for the next M
code (M06) for tool change.
Example: F
N01 T10 ; : The tool pot number corresponding to T10 is output as a code signal.
N02 M06 T11 ; : The cutter compensation value and tool length compensation value
corresponding to T10 become valid, and the tool pot number
corresponding to T11 is output as a code signal.
N03 M06 T10 ; : The compensation values corresponding to T11 become valid, and the
tool pot number corresponding to T10 is output.
Example:
N01 T10 M06 ; : The tool pot number corresponding to T10 is output as a code signal, and
the cutter compensation value and tool length compensation value
corresponding to T10 become valid.
N02 T11 M06 ; : The tool pot number corresponding to T11 is output as a code signal, and
the cutter compensation value and tool length compensation value
corresponding to T11 become valid.

Leave a Reply

Your email address will not be published. Required fields are marked *