Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 14.COMPENSATION FUNCTION
- 501 -
: Tool center path
: Programmed tool path
Tool
G42.2
G40
Operation in circular interpolation
Fig.14.14.1 (c) Operation at compensation start-up and cancellation
(Type B)
(3) Type C
As shown in the following figures, when G41.2, G42.2, or G40 is
specified, a block is inserted which moves the tool
perpendicularly to the movement direction specified in the next
block by the distance of the tool radius.
Tool
G41.2
G40
: Tool center path
: Programmed tool path
Operation in linear interpolation
: Tool center path
: Programmed tool path
Tool
G42.2
G40
Operation in circular interpolation
Fig.14.14.1 (d) Operation at compensation start-up and cancellation
(Type C)

Leave a Reply

Your email address will not be published. Required fields are marked *