Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 538 -
- Programmed point
In programming, the position of the tool tip center is specified.
Ball-end mill
Programmed path
Tool tip center
Flat-end mill
Programmed path
Tool tip center
Corner-radius-end mill
Programmed path
Tool tip center
- Linear interpolation (G01)
When linear interpolation (G01) is specified in tool center point control
mode, the feedrate is controlled so that the tool tip center moves at a
specified feedrate.
Also, in tool center point control (type 2), the feedrate is controlled so
that the tool tip center moves at a specified feedrate regardless of the
setting of bit 2 (FWR) of parameter No. 7711.

Leave a Reply

Your email address will not be published. Required fields are marked *