Fanuc Series 15i/150i-MA (Programming) Operators Manual

14.COMPENSATION FUNCTION PROGRAMMING B-63324EN/03
- 560 -
Alarm and message
No. Message Description
PS1062 ILLEGAL USE OF G41.4/G42.4 (1) Any of the parameters Nos. 6140 to 6146, related to the cutter
compensation for Rotary table, is not correct.
(2) At the start of the rotary table support of cutter compensation
(G41.4/G42.4), axes other than those specified for
parameters Nos. 6140 to 6142 were selected as a plane.
(3) In the mode of the cutter compensation for Rotary table
(G41.4/G42.4), a move command other than G00/G01 (such
as G02) was issued.
Reference item
FANUC Series
15i/150i-MA
PARAMETER
MANUAL
(B-63330EN)
4.22 TOOL OFFSET
PARAMETERS

Leave a Reply

Your email address will not be published. Required fields are marked *