Fanuc Series 15i/150i-MA (Programming) Operators Manual

16.MEASUREMENT FUNCTIOM PROGRAMMING B-63324EN/03
- 568 -
16.3 HIGH SPEED SKIP SIGNAL (G31)
The skip function operates based on a high-speed skip signal
(connected directly to the NC; not via the PMC) instead of an ordinary
skip signal. In this case, up to eight signals can be input. B
Delay and error of skip signal input is 0 - 2 msec at the NC side (not
considering those at the PMC side). This high-speed skip signal input
function keeps this value to 0.1 msec or less, thus allowing high
precision measurement.
For details, refer to the appropriate manual supplied from the machine
tool builder.
Format
G31 IP_ ;
G31 : One-shot G code (If is effective only in the block in
which it is specified

Leave a Reply

Your email address will not be published. Required fields are marked *