Fanuc Series 15i/150i-MA (Programming) Operators Manual

16.MEASUREMENT FUNCTIOM PROGRAMMING B-63324EN/03
- 570 -
- Correspondence to skip signals
Parameter Nos. 7205 to 7208 can be used to specify whether the 4-point
or 8-point skip signal is used (when a high-speed skip signal is used).
Specification is not limited to one-to-one correspondence. It is
possible to specify that one skip signal correspond to two or more G
codes. Also, of parameter No. 7209 can be used to specify dwell.

Leave a Reply

Your email address will not be published. Required fields are marked *