Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 17.CUSTOM MACRO
- 589 -
System variable
number
System variable
name
Attribute Description
#4330 [#_ACTWZP] R Modal information of the block currently being
executed (additional workpiece coordinate system
number)
#4401 to #4430 [#_INTG[n]] R
Modal information of an interrupted block (G code)
Note) Suffix n represents a G code group number.
#4502 [#_INTB] R Modal information of an interrupted block (B code)
#4507 [#_INTD] R Modal information of an interrupted block (D code)
#4508 [#_INTE] R Modal information of an interrupted block (E code)
#4509 [#_INTF] R Modal information of an interrupted block (F code)
#4511 [#_INTH] R Modal information of an interrupted block (H code)
#4513 [#_INTM] R Modal information of an interrupted block (M code)
#4514 [#_INTN] R Modal information of an interrupted block (sequence
number)
#4515 [#_INTO] R Modal information of an interrupted block (program
number)
#4519 [#_INTS] R Modal information of an interrupted block (S code)
#4520 [#_INTT] R Modal information of an interrupted block (T code)
#4530 [#_INTWZP] R Modal information of an interrupted block (additional
workpiece coordinate system number)
- Position information
System variable
number
System variable
name
Attribute Description
#5001 to #5020 [#_ABSIO[n]] R
End point of the immediately preceding block
(workpiece coordinate system)
Note) Suffix n represents an axis number (1 to 20)
#5021 to #5040 [#_ABSMT[n]] R
Specified current position (machine coordinate
system)
Note) The suffix represents an axis number (1 to 20).
#5041 to #5060 [#_ABSOT[n]] R
Specified current position (workpiece coordinate
system)
Note) The suffix represents an axis number (1 to 20).
#5061 to #5080 [#_ABSKP[n]] R
Skip signal position (workpiece coordinate system)
Note) Suffix n represents an axis number (1 to 20).
- Tool length compensation values
System variable
number
System variable
name
Attribute Description
#5081 to #5100 [#_TOFS[n]] R Tool length compensation value
Note) Suffix n represents an axis number (1 to 20).
- Servo positional deviation values
System variable
number
System variable
name
Attribute Description
#5101 to #5120 [#_SVERR[n]] R Servo positional deviation value
Note) Suffix n represents an axis number (1 to 20).

Leave a Reply

Your email address will not be published. Required fields are marked *