Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 17.CUSTOM MACRO
- 655 -
17.9 CODES AND RESERVED WORDS USED IN CUSTOM
MACROS
The following codes can be used in custom macro programs, in
addition to the codes used in ordinary programs.
Explanation
- Codes
(1) ISO codes (represented by hole patterns in tape)
Meaning 87654 321
[OOOOOO
]OOOOOO
#OO OO
* OOO O
= O OOO O O
? OOO OOO
@OO
&OO OO
_ O OO OOO
O OO O OOO
(2) EIA codes
Meaning Codes
[ Code set for parameter No. 7010
] Code set for parameter No. 7011
# Code set for parameter No. 7012
* Code set for parameter No. 7013
= Code set for parameter No. 7014
? Code set for parameter No. 7015
@ Code set for parameter No. 7016
& Code set for parameter No. 7017
_ Code set for parameter No. 7018
O, the same code O as in the program number, must be used. The hole
pattern for [ , ], #, * and = in EIA code must be set as parameters (Nos.
7010-7018).
However, the character with no punched hole cannot be used. Note that
alphabetic codes can be used, but when used as these codes, they are
not used in their proper sense.

Leave a Reply

Your email address will not be published. Required fields are marked *