Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 18.HIGH-SPEED CUTTING FUNCTICNS
- 691 -
NOTE
1 Always specify G05P10000 and G01P0 as a pair.
Fine HPCC mode, after being turned on by G05.1Q1,
cannot be turned off by G05P0. Fine HPCC mode,
after being turned on by G05P10000, cannot be
turned off by G05.1Q0.
2 Setting the MBF bit (bit 6 of parameter 2401) to 1 to
automatically turn on HPCC mode is regarded as
being equivalent to specifying G05.1Q1. To turn off
fine HPCC mode in this case, specify G05.1Q0.
3 When the mode is cancelled by G05P0, the multi-
buffer is left enabled.
Limitation
This function uses look-ahead acceleration/deceleration before
interpolation. For details of the imposed limitations, see Section II-
18.4.

Leave a Reply

Your email address will not be published. Required fields are marked *