Fanuc Series 15i/150i-MA (Programming) Operators Manual

18.HIGH-SPEED CUTTING FUNCTICNS PROGRAMMING B-63324EN/03
- 692 -
18.6 MACHINING TYPE IN HPCC SCREEN PROGRAMMING
(G05.1 OR G10)
General
The high-speed high-precision machining setting screen supports three
machining parameter sets (FINE, MEDIUM, and ROUGH). The
parameter set to use can be selected in MDI mode. Selecting one
parameter set causes the working parameters to be rewritten. If FINE is
selected, for example, the values of the finish machining parameters
listed below are set in the working parameters.
Finish machining
parameter
Working parameter
ACC/DEC LEVEL
1533 (None)
ACC FOR BIPL
1534 1660
(*1)
ACC CHANGE TIME (BELL)
1536 1656
MAX ACCELERATION
1535 1663
(*2)
T-CONST AIPL ACC/DEC
1522 1635
CORNER FEED
1524 1478
FEED FORWARD
COEFFICIENT
1529 1985-3344
(*3)
*1,*2 : These values have been overridden on the acceleration/
deceleration level.
*3 These values apply only when parameter TSP (bit 0 of parameter
No. 8403) is set to 1.
This function enables a machining parameter set to be selected by a
command in a program during operation as well as in MDI mode. The
selected machining parameters are reflected on the high-speed high-
precision machining setting screen.
Format
1. To enter multibuffer mode and select machining-specific parameters at
the same time
G05.1 Q1 R_ ;
R1 : Transfers "finish machining" parameters.
R2 : Transfers "semifinish machining" parameters.
R3 : Transfers "rough machining" parameters.
2. To select machining-specific parameters
G10 L80 R_ ;
R1 : Transfers "finish machining" parameters.
R2 : Transfers "semifinish machining" parameters.
R3 : Transfers "rough machining" parameters.
To issue the G10L80R_ command, the programmable data input option
is required.

Leave a Reply

Your email address will not be published. Required fields are marked *