Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 APPENDIX A.TAPE CODE LIST
- 757 -
NOTE
1 *:Codes with an asterisk that are entered in a comment area are read into memory.
When entered in a significant data area, these codes are ignored.
x: Codes with an x are ignored.
?:Codes with a question mark are ignored when entered in a significant data area that
comes before the program number. These codes are read into memory when entered
in any other significant data area or comment area. However, when the custom macro
option is used, the following codes are read into memory even when entered in a
significant data area that comes before the program number.
When ISO codes are used: #, &, *, =, [and]
When EIA codes are used: (codes set by parameter)
4 Codes not shown in this table are ignored as long as their parity is correct.
5 Codes with incorrect parity cause a TH alarm to be generated (except when found in a
comment area, in which case they are ignored.)
6 When EIA codes are used, the code with all eight holes punched is treated as a special
case and does not generate a parity alarm.

Leave a Reply

Your email address will not be published. Required fields are marked *