Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 APPENDIX F.ALARM LIST
- 791 -
Number Message Contents
PS0302 ILLEGAL DATA NUMBER A non-existent data No. was found while loading
parameters or pitch error compensation data from a tape or
by entry of the G10 parameter.
This alarm is also generated when illegal word values are
found.
An invalid value was specified for address R in a pattern
program command specific to a particular machining
purpose on the high-speed, high-precision setting screen.
PS0303 ILLEGAL AXIS NUMBER An axis No. address exceeding the maximum number of
controlled axes was found while loading parameters from a
tape or by entry of the G10 parameter.
PS0304 TOO MANY DIGIT Data with too many digits was found while loading
parameters or pitch error compensation data from a tape.
PS0305 DATA OUT OF RANGE Out-of-range data was found while loading parameters or
pitch error compensation data from a tape.
The values of the data setting addresses corresponding to
L Nos. during data input by G10 was out of range.
This alarm is also generated when NC programming words
contain out-of-range values.
PS0306 MISSING AXIS NUMBER A parameter which requires an axis to be specified was
found without an axis No. (address A) while loading
parameters from a tape.
PS0307 ILLEGAL USE OF MINUS SIGN Data with an illegal sign was found while loading
parameters or pitch error compensation data from a tape,
or by entry of the G10 parameter.
A sign was specified to an address that does not support
the use of signs.
PS0308 MISSING DATA An address not followed by a numeric value was found
while loading parameters or pitch error compensation data
from a tape.
PS0330 ILLEGAL SPINDLE NUMBER An spindle No. address exceeding the maximum number of
controlled spindles was found while loading parameters
from a tape or by entry of the G10 parameter.
PS0332 DATA WRITE LOCK ERROR Could not load data while loading parameters, pitch error
compensation data and work coordinate data from tape.
PS0333 DATA WRITE ERROR Could not write data while loading data from tape.
PS0360 PARAMETER OUT OF RANGE
(TLAC)
Illegal parameter setting. (Set value is out of range.)
PS0361 PARAMTER SETTING ERROR 1
(TLAC)
Illegal parameter setting. (axis of rotation setting)
PS0362 PARAMETER SETTING ERROR 2
(TLAC)
Illegal parameter setting (tool axis setting)
PS0370 PARAMETER SETTING ERROR
(DM3H-1)
Out-of-range data was set during setting of the 3-
dimensional handle feed parameter.
PS0371 PARAMETER SETTING ERROR
(DM3H-2)
An illegal axis of rotation was set during setting of the 3-
dimensional handle feed parameter.
PS0372 PARAMETAR SETTING ERROR
(DM3H-3)
An illegal master axis was set during setting of the 3-
dimensional handle feed parameter.
PS0373 PARAMETER SETTING ERROR
(DM3H-4)
An illegal parallel axis or twin table was set during setting of
the 3-dimensional handle feed parameter.
PS0400 PROGRAM NOT MATCH The program in memory does not match the program
stored on tape.
Multiple programs cannot be matched continuously when
parameter No. 2200#3 is set to "1".
Set parameter No. 2200#3 to "0" before executing a match.
PS0410 G37 IMPROPER AXIS COMMAND No axis or 2 or more axes were specified in the automatic
tool measurement instruction (G37) block.
PS0411 G37 SPECIFIED WITH H CODE An H code was specified in the same block as an automatic
tool-length measurement instruction (G37).
PS0412 G37 OFFSET NO. UNASSIGNED No H code was specified in the automatic tool
measurement instruction (G37) block.

Leave a Reply

Your email address will not be published. Required fields are marked *