Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 APPENDIX F.ALARM LIST
- 803 -
Number Message Contents
SR0960 ACCESS ERROR (MEMORY CARD) Illegal memory card accessing
This alarm is also generated during reading when reading
is executed up to the end of the file without detection of the
EOR code.
SR0961 NOT READY (MEMORY CARD) The memory card is not ready.
SR0962 CARD FULL (MEMORY CARD) The memory card has run out of space.
SR0963 CARD PROTECTED (MEMORY
CARD)
The memory card is write-protected.
SR0964 NOT MOUNTED (MEMORY CARD) The memory card could not be mounted.
SR0965 DIRECTORY FULL (MEMORY CARD) The file could not be generated in the root directory for the
memory card.
SR0966 FILE NOT FOUND (MEMORY CARD) The specified file could not be found on the memory card.
SR0967 FILE PROTECTED (MEMORY CARD) The memory card is write-protected.
SR0968 ILLEGAL FILE NAME (MEMORY
CARD)
Illegal memory card file name
SR0969 ILLEGAL FORMAT (MEMORY CARD) Illegal memory card format
SR0970 ILLEGAL CARD (MEMORY CARD) This memory card cannot be handled.
SR0971 ERASE ERROR (MEMORY CARD) An error occurred during memory card erase.
SR0972 BATTERY LOW (MEMORY CARD) The memory card battery is low.
SR0973 FILE ALREADY EXIST A file having the same name already exists on the memory
card.
SR1030 NOT READY (DATA SERVER) The board is not ready in the Ethernet/data server board
function.
SR1031 BUSY (DATA SERVER) The board is busy in the Ethernet/data server board
function.
SR1032 BOARD ERROR (DATA SERVER) An error was returned from the board in the Ethernet/data
server board function.
SR1033 TIME OVER (DATA SERVER) The CNC registered a time-out in the Ethernet/data server
board function.
SR1034 CNC ERROR (DATA SERVER) An internal CNC error occurred by the Ethernet/data server
board function.
SR1035 SEQUENCE ERROR (DATA
SERVER)
A contradiction occurred in the CNC by the Ethernet/data
server board function.
SR1036 MODE ERROR (DATA SERVER) The mode could not be changed in the Ethernet/data server
board function.
SR1037 DOUBLE OPEN (DATA SERVER) An attempt was made to open the file twice in the
Ethernet/data server board function.
F.4 SW ALARM (ALARMS RELATED TO PARAMETER
WRITING)
Number Message Contents
SW0000 PARAMETER ENABLE SWITCH ON The parameter setting is enabled (PWE, one bit of
parameter No. 8000 is set to "1").
To set the parameter, turn this parameter ON. Otherwise,
set to OFF.

Leave a Reply

Your email address will not be published. Required fields are marked *