Fanuc Series 15i/150i-MA (Programming) Operators Manual

F.ALARM LIST APPENDIX B-63324EN/03
- 814 -
Number Message Contents
SP0976 SERIAL SPINDLE COMMUNICATION
ERROR
The amplifier No. could not be set to the serial spindle
amplifier.
SP0977 SERIAL SPINDLE COMMUNICATION
ERROR
An error occurred in the spindle control software.
SP0978 SERIAL SPINDLE COMMUNICATION
ERROR
A time-out was detected during communications with the
serial spindle amplifier.
SP0979 SERIAL SPINDLE COMMUNICATION
ERROR
The communications sequence was no longer correct
during communications with the serial spindle amplifier.
SP0980 SERIAL SPINDLE AMP. ERROR Defective SIC-LSI on serial spindle amplifier
SP0981 SERIAL SPINDLE AMP. ERROR An error occurred during reading of the data from SIC-LSI
on the analog spindle amplifier side.
SP0982 SERIAL SPINDLE AMP. ERROR An error occurred during reading of the data from SIC-LSI
on the serial spindle amplifier side.
SP0983 SERIAL SPINDLE AMP. ERROR Could not clear on the spindle amplifier side.
SP0984 SERIAL SPINDLE AMP. ERROR An error occurred during re-initialization of the spindle
amplifier.
SP0985 SERIAL SPINDLE CONTROL ERROR Failed to automatically set parameters
SP0986 SERIAL SPINDLE CONTROL ERROR An error occurred in the spindle control software.
SP0987 SERIAL SPINDLE CONTROL ERROR Defective SIC-LSI on the CNC
SP0988 SPINDLE CONTROL ERROR An error occurred in the spindle control software.
SP0989 SPINDLE CONTROL ERROR An error occurred in the spindle control software.
SP0996 ILLEGAL SPINDLE PARAMETER
SETTING
Illegal spindle and spindle motor setting
SP0997 SPINDLE CONTROL ERROR The newly selected spindle No. by the spindle selection
function could not be reflected in parameters.
SP0998 SPINDLE CONTROL ERROR An error occurred in the spindle control software.
SP0999 SPINDLE CONTROL ERROR An error occurred in the spindle control software.
F.10 OH ALARM (ALARMS RELATED TO OVERHEAT)
Number Message Contents
OH0001 LOCKER OVERHEAT CNC cabinet overheat
OH0002 FAN MOTOR STOP OCB cooling fan motor abnormality

Leave a Reply

Your email address will not be published. Required fields are marked *