Fanuc Series 15i/150i-MA (Programming) Operators Manual

4.INTERPOLATION FUNCIONS PROGRAMMING B-63324EN/03
- 70 -
Fig.4.10 (d) When Bit 6 (CYS) of Parameter No. 6004 Is Set to 1
2) When bit 6 (CYS) of parameter No. 6004 is set to 0
Cutting point compensation is not performed between blocks
N1 and N2. Whether to apply cutting point compensation
between block N2 and N3 is determined by taking the cutting
point compensation value between blocks N2 and N3 (V1 in
the figure) into consideration.
Fig.4.10 (e) When Bit 6 (CYS) of Parameter No. 6004 Is 0
Z-axis
C-axis on the
cylindrical surface
Y-axis
S2
C2
C2
V
Tool center path
Programmed path
V FC-axis component of C2 - C1
C1 FCutting surface of block N1
C2 FCutting surface after the end of block N1
S1
C1
N1
N2
N3
Z-axis
C-axis on the
cylindrical surface
Y-axis
S2
C1
C2
V
Tool center path
Programmed path
V FC-axis component of C2 - C1
C1 FCutting surface of blocks N1 and N2
C2 FCutting surface at the end of block N3
S1
C1
N1
N2
N3

Leave a Reply

Your email address will not be published. Required fields are marked *