FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

B–62753EN/01
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
103
Notes
1. Several types of connectors are available for use at the
other end of the cable leading to connector CNB1. Refer to
brochures of PHOENIX CONTACT GmbH & Co..
The connector used on the machine operator’s panel
interface unit side is MSTBVA2.5/12-G-5.08.
2. Crimped type cable connector is available for CA40. For
purchase from FANUC, please specify as below.
A02B-0029-K890 : Solder type
A02B-0029-K892 : Crimped type

Leave a Reply

Your email address will not be published. Required fields are marked *