FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B–62753EN/01
108
The operators panel connection unit (A16B-2200-0660, 0661) is
connected to the control unit through the FANUC I/O Link and is used for
interfacing with the machine operators panel.
The electric interface and pin layout of the connectors CM1 to CM4 are
fully compatible with those for Series 15. There are two units available
depending on the number of I/O points.
Specification Input Output
A16B-2200-0660 96 points 64 points
A16B-2200-0661 64 points 32 points
Machine
operator’s
panel
24V DC power
Control unit
or I/O unit
JD1B
To next device
Operator’s panel connection unit
A16B-2200-0660,0661
BURNDY JAPAN, LTD.
3P CONNECTOR
(Brown)
Housing : SMS3PNS-5
Contact : RC16M-SCT3
If there is no equipment
beyond this connection
unit, JD1A can remain
open.
JDIA
CM1
CM2
CM3
CM4
CP61
Power supply input specification
Voltage : 24 VDC "10%
Capacity : 500 + 7.3 ³ n mA
n : number of inputs that turn on simultaneously
1 +24V
2 GND
3
JD1A
6.5
CONNECTION OF
OPERATOR’S PANEL
CONNECTION UNIT

Leave a Reply

Your email address will not be published. Required fields are marked *