FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

B–62753EN/01
6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
153
The PMC addresses assigned to this I/O card start from X1000.0 for input
signals and from Y1000.0 for output signals. The I/O card is classified
into eight types, A to H, according to the number of I/O lines. The
following addresses are assigned to each type:
X1000
X1001
X1002
X1003
X1004
X1005
X1006
X1007
X1008
X1009
X1010
X1011
X1012
X1013
X1014
X1015
X1016
X1017
X1018
X1019
D or H
76543210
(Note 1)(Note 2)
(Note 1)
(Note 1)
(Note 2)
C or G
B or F
A or E
Notes
1. Addresses X1004, X1008, and X1009 are assigned to
those signals which are directly referenced by the CNC.
When these signals are used, the addresses cannot be
assigned to other interface signals.
2. Small–delay receivers are used for addresses X1004 and
X1013.
6.9.6
Address map
Input Signal

Leave a Reply

Your email address will not be published. Required fields are marked *