FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

C. 20–PIN INTERFACE CONNECTORS AND CABLES
B–62753EN/01
284
C
20-PIN INTERFACE CONNECTORS AND CABLES
Model: PCR–EV20MDT manufactured by HONDA TSUSHIN.
The connector for the PC board has been specially developed to support
FANUC’s high–mounting density. PCR connectors made by HONDA
TSUSHIN are compatible with the mating part of the connector and can
be selected for the cable connection.
The cable connector is separated into a body and a housing. The
connectors available are shown below. Models marked with (*) have
been customized for FANUC; those not so marked are mass produced as
standard products.
Cable
connector
Housing
Pulse
coder and
coaxial
cable
HONDA
TSUSHIN
General
purpose
Connector
body
PCR–E20FA
(Separate–wire
press–mount type)
PCR–E20FS
(Solder type)
PCS–E20LA
(Metal)
PCR–V20LA*
(Plastic)
FI40–2015S*
(Solder type with
15 pins)
FI–20–CV*
(Plastic)
HIROSE
ELECTRIC
HIROSE
ELECTRIC
Connector
body
Housing
HONDA
TSUSHIN
HONDA
TSUSHIN
HONDA
TSUSHIN
Separate–wire press–mount type
Connector : PCR–E20FA (HONDA TSUSHIN KOGYO CO., LTD.)
28–AWG wires are assembled at a time. Generally, it is much more cost
effective to assemble a cable this way than by using solder or press–mount
type connectors. The tools required are :
– Cassette for wire arrangement :
JGPS–015–1/1–20 (HONDA TSUSHIN KOGYO CO., LTD.)
– Base for cassette :
JGPS–014 (HONDA TSUSHIN KOGYO CO., LTD.)
– Press–mount locator :
PCS–K1 (HONDA TSUSHIN KOGYO CO., LTD.)
– Hand press : MFC–K1 (HONDA TSUSHIN KOGYO CO., LTD.)
Connector for the PC
board
Cable connector
Required tools for
Connection of cable
connector

Leave a Reply

Your email address will not be published. Required fields are marked *