FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

B–62753EN/01
3. INSTALLATION
25
Connect the 0 V line of the electronic circuit in the control unit with the
ground plate of the cabinet via the signal ground (SG) terminal.
The SG terminal is located on the printed circuit board at the rear of the
control unit.
Signal
ground
(SG)
M4
(Only thread
hole)
M3
(With thread)
Ground cable
Wire with a sectional
area 2mm
2
or more
Ground plate of
the cabinet
System ground
Ground cable
M3
PCB
SG
Control unit
3.7.3
Connecting the Signal
Ground (SG) of the
Control Unit

Leave a Reply

Your email address will not be published. Required fields are marked *