FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

B–62753EN/01
3. INSTALLATION
35
Procedure for replacing the battery
1 Use a lithium battery (ordering drawing number:
A02B–0222–K102 for power supply AI/BI;
A02B–0177–K106 for power supply C)
2 Turn on the power of CNC.
3 Remove the battery case from the front panel of the power supply
unit. The case can be removed easily by holding the top and bottom of
it and pulling.
4 Remove the connector from the battery.
5 Replace the battery and reconnect the connector.
6 Install the battery case.
7 Turn off the power of CNC.
Power
supply
unit
Battery
unit
BATTERY
Cable side
connector
Battery
PCB side
connector
Front panel of
Power supply unit
Replacing the Battery

Leave a Reply

Your email address will not be published. Required fields are marked *