FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B–62753EN/01
72
*SIN
01
03
SIN
02
SOUT
04
06
*SOUT
05
08
07
09
+5V
10
0V
11
13
0V
12
0V
14
16
0V
15
18
17
+5V
+5V
19
20
0V
0V
SIN(01)
*SIN(02)
SOUT(03)
*SOUT(04)
+5V(09)
+5V(18)
+5V(20)
0V(11)
0V(12)
0V(13)
0V(14)
0V(15)
0V(16)
(03)SOUT
(04)*SOUT
(01)SIN
(02)*SIN
(09)+5V
(18)+5V
(20)+5V
(11)0V
(12)0V
(13)0V
(14)0V
(15)0V
(16)0V
Unit side
JD1A,JD1B
Adapter side
JD1
Recommended connector for cable side :
PCR–E20FS (made by HONDA TSUSHIN KOGYO CO., LTD.)
Recommended cable (wire material) : A66L–0001–0284#10P
Cable length : Max. 2 m (when the recommended cable is used)
Specification : A66L – 6001 – 0009
(Make sure to use one with this specification)
Cable length: Max. 200 m
Power voltage : 4.75V to 5.25V (at the receiving end)
Consumption current : 200mA
The optical link adapter enclosure is not fully sealed ; install it with
the CNC control unit in the fully enclosed cabinet.
Ground the case using the case fixing screw of the optical link adapter.
The optical link adapter is light, and it may not be necessary to mount
it with screws. However, keep it from coming in contact with other
circuits to prevent possible short–circuits. When mounting the optical
link adapter in a cabinet, attach it with an L–type fitting using the case
fixing screws (M3) of the optical link adapter.
L fitting
For making up an I/O link using the optical link adapter, the following
parts are necessary:
Optical I/O link adapter 2
Interunit connecting cable 2
Optical cable 1
Interunit connecting
cables
Optical cable
Power source
Installation conditions
Required parts

Leave a Reply

Your email address will not be published. Required fields are marked *