FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

6. CONNECTION OF I/O UNITS TO
MACHINE INTERFACE
B–62753EN/01
76
Connect the following power source to the connector CP32 of the
interface module (AIF01A or AIF01B).
Voltage : 24VDC±10%
Current : Determine from Table 6.3.6.
+24V
2
1
GND
3
CP32
AIF01A/AIF01B
BURNDY JAPAN, LTD. tripolar connector (Brown)
Housing : SMS3PNS–5
Contact : RC16M–SCT3
24VDC
Caution
Turn ON the power for the I/O unit just before or when the
power for the CNC is turned ON. When the CNC power is
turned OFF, make sure to turn the power to the I/O unit OFF
as well.
t
ON
OFF
ON
OFF
Power for the
master device
Power for the
I/O unit
t : more than –500ms
(Turn ON of the power for I/O unit can be late 500ms or less.)
6.3.5
Connecting Input
Power Source

Leave a Reply

Your email address will not be published. Required fields are marked *