FANUC Series 16/18/160/180-Model C Connection Manual (Hardware)

B–62753EN/01
2. CONFIGURATION
3
2
CONFIGURATION
The following figure shows the configuration of the electrical system of
the machine tool with which this control is used.
This manual describes how to connect the units illustrated in this diagram.
The machine tool body, machine operators panel, power magnetic
circuit, and sensor/actuator are specific to the machine tool and are the
builders responsibility. This manual does not cover the internal
connection of these units to the machine tool. The numbers in parentheses
shown in the diagram are section references for this manual.
Manual pulse generator
(7.3)
Note 1 Refer to the ”FANUC I/O Unit Model A Connecting Maintenance Manual (B-61813E)”.
Note 2 Refer to the following manuals:
“FANUC AC Servo Motor α Series Descriptions (B-65142E)”
“FANUC AC Spindle Motor α Series Descriptions (B-65152E)”
“FANUC CONTROL MOTOR AMPLIFIER α Series Descriptions (B–65162E)”
Heat
exchanger
(3.6)
CRT/MDI
unit
Machine
operator’s
panel
Operator’s
panel interface
(6.4, 6.5)
I/O device
Control unit
(3.8)
I/O unit
Servo
amplifier
(7.10)
(6.2, 6.3, 6.7–6.9)
Power
magnetic
circuit
Multi–tap
transformer for
the control unit
Spindle
motor
Servo
motor
Sensor /
actuator
Spindle
amplifier
(7.9)
Power
supply
(7.4, 7.5, 7.6)
Relay connector (7.2)
Machine tool magnetic cabinet
(Note1)
(Note 2)
Host computer
(5)
(Note 2)
Distribution
board

Leave a Reply

Your email address will not be published. Required fields are marked *