FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
5. FEED FUNCTIONS
B–62754EN/01
82
Dwell G04 X_ ; or G04 U_ ; or G04 P_ ;
X_ : Specify a time (decimal point permitted)
U_ : Specify a time (decimal point permitted)
P_ : Specify a time (decimal point not permitted)
By specifying a dwell, the execution of the next block is delayed by the
specified time.
Bit 1 (DWL) of parameter No. 3405 can specify dwell for each rotation
in feed per rotation mode (G99).
Table 5.4 (a)
Command value range of the dwell time (Command by X)
Increment system Command value range Dwell time unit
IS–B
0.001 to 99999.999
sorrev
IS–C
0.0001 to 9999.9999
s
or
rev
Table 5.4 (b)
Command value range of the dwell time (Command by P)
Increment system Command value range Dwell time unit
IS–B 1 to 99999999 0.001 s or rev
IS–C 1 to 99999999 0.0001 s or rev
5.4
DWELL (G04)
Format
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *