FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
8. COORDINATE SYSTEM
B–62754EN/01
96
When the coordinate system actually set by the G50 command or the
automatic system setting deviates from the programmed work system, the
set coordinate system can be shifted (see III–3.1).
Set the desired shift amount in the work coordinate system shift memory.
Z
X
z
x
X–Z:
Coordinate system in programming
x–z : Current set coordinate system with shift amount 0
(coordinate system to be modified by shifting)
O
O’
Set the shift amount from Oto O in the work coordinate system shift memory.
Shift
Fig. 8.2.5 (a) Workpiece Coordinate System shift
See Section 11.4.5 of Part III for how to specify the distance the work
coordinate system is shifted.
8.2.5
Workpiece Coordinate
System shift
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *