FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
8. COORDINATE SYSTEM
B–62754EN/01
98
WARNING
1 The local coordinate system setting does not change the
workpiece and machine coordinate systems.
2 When G50 is used to define a work coordinate system, if
coordinates are not specified for all axes of a local
coordinate system, the local coordinate system remains
unchanged.
If coordinates are specified for any axis of a local coordinate
system, the local coordinate system is canceled.
3 G52 cancels the offset temporarily in tool nose radius
compensation.
4 Command a move command immediately after the G52
block in the absolute mode.
5 Whether the local coordinate system is canceled upon reset
depends on the specified parameters. The local coordinate
system is canceled upon reset when bit 6 (CLR) of
parameter No. 3402 or bit 3 (RLC) of parameter No. 1202
is set to 1.

Leave a Reply

Your email address will not be published. Required fields are marked *