FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
9. COORDINATE VALUE
AND DIMENSION
103
Numerical values can be entered with a decimal point. A decimal point
can be used when entering a distance, time, or speed. Decimal points can
be specified with the following addresses:
X, Y, Z, U, V, W, A, B, C, I, J, K, R, and F.
There are two types of decimal point notation: calculator–type notation
and standard notation.
When calculator–type decimal notation is used, a value without decimal
point is considered to be specified in millimeters. When standard decimal
notation is used, such a value is considered to be specified in least input
increments. Select either calculator–type or standard decimal notation by
using the DPI bit (bit 0 of parameter 3401).Values can be specified both
with and without decimal point in a single program.
Program command Pocket calculator
type decimal point
programming
Standard type decimal
point programming
X1000
Command value with-
out decimal point
1000mm
Unit : mm
1mm
Unit : Least input increment
(0.001 mm)
X1000.0
Command value with
decimal point
1000mm
Unit : mm
1000mm
Unit : mm
WARNING
In a single block, specify a G code before entering a value. The position of decimal point may
depend on the command.
Examples:
G20; Input in inches
X1.0 G04; X1.0 is considered to be a distance and processed as X10000. This command
is equivalent to G04 X10000. The tool dwells for 10 seconds.
G04 X1.0; Equivalent to G04 X1000. The tool dwells for one second.
NOTE
1 Fractions less than the least input increment are truncated.
Examples:
X1.2345; Truncated to X1.234 when the least input increment is 0.001 mm.
Processed as X1.2345 when the least input increment is 0.0001 inch.
2 When more than eight digits are specified, an alarm occurs. If a value is entered with a decimal
point, the number of digits is also checked after the value is converted to an integer according
to the least input increment.
Examples:
X1.23456789; P/S alarm 003 occurs because more than eight digits are specified.
X123456.7; If the least input increment is 0.001 mm, the value is converted to integer
123456700. Because the integer has more than eight digits, an P/S alarm 003
occurs.
9.3
DECIMAL POINT
PROGRAMMING



Leave a Reply

Your email address will not be published. Required fields are marked *