FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
10. SPINDLE SPEED FUNCTION
105
10
SPINDLE SPEED FUNCTION
The spindle speed can be controlled by specifying a value following
address S.
In addition, the spindle can be rotated by a specified angle.
This chapter contains the following topics.
10.1SPECIFYING THE SPINDLE SPEED WITH A CODE
10.2SPECIFYING THE SPINDLE SPEED VALUE DIRECTLY
(S5–DIGIT COMMAND)
10.3CONSTANT SURFACE SPEED CONTROL (G96, G97)
10.4SPINDLE SPEED FLUCTUATION DETECTION
FUNCTION (G25, G26)
10.5SPINDLE POSITIONING FUNCTION

Leave a Reply

Your email address will not be published. Required fields are marked *