FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
11. TOOL FUNCTION (T FUNCTION)
B–62754EN/01
120
O0001 ;
G10L3 ;
P001L0150 ;
T0011 ;
T0132 ;
T0068 ;
P002L1400 ;
T0061;
T0241 ;
T0134;
T0074;
P003L0700 ;
T0012;
T0202 ;
G11 ;
M02 ;
Data of group 1
Data of group 2
Data of group 3
The group numbers specified in P need not be serial. They need not be
assigned to all groups, either. When using two or more offset numbers
for the same tool in the same process, set as follows;
P004L0500;
T0101;
T0105;
T0108;
T0206;
T0203;
T0202;
T0209;
T0304;
T0309;
P005L1200;
T0405;
The tools in group 4 are used from (1)
to (2) to (3).
Each tool is used 500 times (or for
500 minutes).
When this group is specified three
times in one process, the offset num-
bers are selected in the following or-
ders:
Tools (1): 010508
Tools (2): 06030209
Tools (3): 0409
Tape format Meaning
(3)
(1)
(2)
Example
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *