FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
12. AUXILIARY FUNCTION
B–62754EN/01
123
12
A UXILIARY FUNCTION
There are two types of auxiliary functions ; miscellaneous function (M
code) for specifying spindle start, spindle stop program end, and so on,
and secondary auxiliary function (B code ) .
When a move command and miscellaneous function are specified in the
same block, the commands are executed in one of the following two
ways:
i) Simultaneous execution of the move command and miscellaneous
function commands.
ii) Executing miscellaneous function commands upon completion of
move command execution.
The selection of either sequence depends on the machine tool builders
specification. Refer to the manual issued by the machine tool builder for
details.

Leave a Reply

Your email address will not be published. Required fields are marked *