FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
13. PROGRAM CONFIGURATION
B–62754EN/01
132
A tape end is to be placed at the end of a file containing NC programs.
If programs are entered using the automatic programming system, the
mark need not be entered. The mark is not displayed on the CRT display
screen. However, when a file is output, the mark is automatically output
at the end of the file.
If an attempt is made to execute % when M02 or M03 is not placed at the
end of the program, the P/S alarm (No. 5010) is occurred.
Table 13.1(d) Code of a tape end
Name ISO
code
EIA
code
Notation in this
manual
Tape end % ER %
D Tape end

Leave a Reply

Your email address will not be published. Required fields are marked *