FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
14. FUNCTIONS TO SIMPLIFY
PROGRAMMING
151
G94X(U)__ Z(W)__ F__ ;
X axis
0
4(R)
X/2
3(F)
Z axis
1(R)
2(F)
U/2
Z
W
(R)……Rapid traverse
(
F)……Specified by F code
X/2
U/2
Z
Fig. 14.1.3 (a) Face Cutting Cycle
In incremental programming, the sign of numbers following addresses U
and W depends on the direction of paths 1 and 2. That is, if the direction
of the path is in the negative direction of the Z axis, the value of W is
negative.
In single block mode, operations 1, 2, 3, and 4 are performed by pressing
the cycle start button once.
14.1.3
End Face Turning
Cycle (G94)
D Face cutting cycle

Leave a Reply

Your email address will not be published. Required fields are marked *