FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62754EN/01
206
1. When a tool geometry offset number and tool wear offset number are
specified with the last two digits of a T code
(when LGN, bit 1 of parameter No.5002, is set 0),
N1 X50.0 Z100.0 T0202 ; Specifies offset number 02
N2 Z200.0 ;
N3 X100.0 Z250.0 T0200 ; Cancels offset
Programmed
path after work
coordinate
system shift
Absolute command
Offset cancelOffset cancel
Tool path after offsetTool path after offset
OffsetOffset
N1
N2
N3
Programmed
path after work
coordinate
system shift
Absolute command
NOTE
When LGC, bit 5 of parameter No.5002, is set to 0,
specifying offset number 0 does not cancel tool geometry
offset.
2. Assume that geometry offset is not cancelled with offset No.0
(Set the parameter (No.5002#1).)
N1 X50.0 Z100.0 T0202 ; Tool selection number (specified tool
geometry offset number 02)
N2 Z200.0 ;
N3 X100.0 Z250.0 T0000 ; Cancels offset
N1
N2
N3
Offset cancel
Tool path after offset
Offset
Programmed
path after work
coordinate
system shift
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *