FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
15. COMPENSATION FUNCTION
B–62754EN/01
210
When the tool geometry/wear compensation option is not selected
LGN (No.5002#1) LGT (No.5002#4) LGC (No.5002#5)
The geometry offset number is:
0: Same as the wear offset
number
1: Same as the tool selection
number
Geometry compensation is
applied:
0: Based on shift of the
coordinate system
1: Based on movement of the
tool
The geometry offset is:
0: Not canceled with T00
1: Canceled with T00
Result
LGN is unrelated. LGT is unrelated.
LGC is unrelated.
The tool position offset number
always uses the low order
Tool position offset is always
a
pp
lied based on the movement
LWM (No.5002#6)
always
uses
the
low
order
digits.
applied
based
on
the
movement
of the tool.
Tool position offset is applied:
0: By means of T code
1: By means of movement
along axis
LWM=0
LWM=1
Canceled
Not canceled

Leave a Reply

Your email address will not be published. Required fields are marked *