FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
15. COMPENSATION FUNCTION
257
WARNING
2 When a compensation axis is specified in a G53 command
in tool–tip radius compensation mode, the vectors for other
compensation axes are also canceled. This also applies
when bit 2 (CCN) of parameter No. 5003 is set to 1. (The
FS15 cancels only the vector for the specified axis. Note
that the FS15 type cancellation differs from the actual FS15
specification in this point.)
Example)
When bit 2 (CCN) of parameter No. 5003 is set to 0
[FS15 type]
r
s
G00
(G41 X_ Z_)
s
G00s
G53 Z_

Leave a Reply

Your email address will not be published. Required fields are marked *