FANUC Series 16/18/160/180-Model C for Lathe Operator Manual

PROGRAMMING
B–62754EN/01
15. COMPENSATION FUNCTION
259
- When bit 2 (CCN) of parameter No. 5003 is set to 0
O×××× ;
G91 G41_ ;
:
G28 X40. Z0 ;
:
r
s
(G42 G01)
s
s
s
G00
G01G28/30/30.1
Intermediate position
Reference position or floating
reference position
- When bit 2 (CCN) of parameter No. 5003 is set to 1
r
s
(G42 G01)
s
s
s
G00
G01
G28/30/30.1
[FS15 type]
Intermediate position
Reference position or floating
reference position
- When bit 2 (CCN) of parameter No. 5003 is set to 0
O×××× ;
G91 G41_ ;
:
G28 X0 Y0 ;
:
(G41 G01)
r
r
s
s
s
G00
G01
G28/30/30.1
Intermediate position
Reference position or floating
reference position
Start–up
- When bit 2 (CCN) of parameter No. 5003 is set to 1
[FS15 type]
(G41 G01)
r
s
s
s
G00
G01
G28/30/30.1
Intermediate position
Reference position or
floating reference position
S G28, G30, or G30.1
command in offset mode
(with movement to both
an intermediate position
and reference position
performed)
S G28, G30, or G30.1
command in offset mode
(with movement to an
intermediate position not
performed)

Leave a Reply

Your email address will not be published. Required fields are marked *